Acid Curing Clear Matt (Cat @10%CD070)

Standard Grade two components acid curing clear matt finishes, modified with exceptional resin and high solid contents, exhibits good clarity, plasticity, scratch resistance and very good build, indicated to varnish modern and old style furniture, frames and wooden manufacturers of different nature.

Suitable for interior use and could be used as sealer and topcoat in the same time due to its excellent sanding properties.

All timber species must be fully aged with a moisture content of less than 15%. The surface must be dry, clean and free from contaminations. Natural oil or gum must be removed by solvent cleaning.
Always check compatibility with required [stains / sealers] or similar pretreatment. Good sanding to substrate utilizing paper no. [120] is essential, as is adequate sanding and removal of dust prior of application of [DT72XX] Ritver Melamine Cure clear –Matt. Apply the Melamine Cure Sealer in 2-3 cross coats according to the required coverage. Followed (after drying) with sanding paper no. [220] and [400] to create perfection. Remove the dust and apply [DT72XX] as per required shade.

CATALYST

Pot Life 6 hrs. @ 25°C
Stir product well with a flat paddle. Add the correct quantity of hardener and stir till homogeneous. Thin to required viscosity. For details of spray equipment contact Ritver Technical Services Department.

Dilution
Utilize [TN190] NC Thinner depending on the application system used. In general 25% thinner is added to achieve an application viscosity; this is suitable for spray application. For Curtain Coater dilute with 20% [TN190] NC Thinner.
In case of hot climate and higher humidity add 5% of [TN122] NC Retardant Thinner.

Depends on the finishes required but in general an appropriate rate is 130g / sq. m. The number of coats depends on the surface preparation the porosity of the substrate, and the finish required.
This quality can be reduced if applied over polyester.

Cleaning
Clean all tools and equipment immediately after use with [TC010] Tool cleaning.
Caution
Do not use when humidity levels may cause surface condensation (maximum 85%), during rainy conditions or if temperatures are likely to fall below 5°C during application and drying. Protect from frost.

Available in 3.5Ltr, 18Ltr.
Store in a cool and well ventilated place. Keep away from direct sunlight. Maximum 6 months in unopened container, stored in a cool and dry condition at 25°C.

This material is flammable and must not be exposed to naked flames. Use only in well ventilated areas. In case of insufficient ventilation during application, wear
suitable respiratory equipment. Do not breathe vapor / spray. In case of contact with eyes, rinse immediately with plenty of sweet water and seek medical advice. In case of contact with skin, wash immediately with soap and water or a recognized skin cleanser.
Keep away from sources of ignition. No Smoking. Keep out of reach of children.