logo
icon
logo

Acrilic anti fouling (One Pack)

Ritver Acrylic Antifouling is a TBTO free Acrylic copolymer based anti fouling paint . The product e ffectively controls the growth o f fouling even wi thout the use o f tin based biocides which makes it an ideal product to use even in small marine vessels . The continuous release o f the biocides and the gradual polishing o f its sur face ensure an excellent fouling control that can last up to 24 months .

SKU: PS3107

  • spe_5

    Finish

    Semi-Gloss to Gloss
  • spe_5

    Colour

    Oxide Red / Pinkish Red
  • spe_5

    Specific gravity

    1.25 ± 0.02
  • spe_5

    Solids by Volume

    46 ± 2%
  • spe_5

    Flash point

    28oC
  • USE
  • SURFACE PREPARATION
  • APPLICATION METHODS
  • TYPICAL PAINT SYSTEM
  • STORAGE & SHELF LIFE
  • SAFETY PRECAUTION

Substrates: Hulls of marine going vessels.
Area of Use: Exterior

Always ensure that the surface to be painted must be free of dirt oil and grease. When applied over a fully cured coatings, lightly sand the surface with a fine grit sandpaper, #320 to #400  will be enough to provide good adhesion.

Adequate ventilation should always be observed when applying Ritver Antifouling SP. This will ensure proper drying of the material. Never apply this product in adverse weather conditions such as when the temperature is below 5 oC or when the humidity level is above 90%. The surface temperature should always be kept at not less than 3 degree above dew point. In confined spaces constant purging of air during application and drying is necessary to eliminate solvent vapors for reason of health and safety and to assist solvent evaporation.
Application:
The recommended method of application is by airless or air assisted airless spray. However the product can also be applied using conventional spray or brush. The addition of Ritver Marine Thinner depends on the application methods used which is in the range of 10 to 20 percent.

Ritver Acrylic Antifouling Ritver Epoxy Zinc Chromate Primerr 1 mil
*Or as per Ritver technical advice Ritver Epoxy Zinc Rich Primer 4 – 6 mils
Ritver Epoxy High Build Intermediate 8 – 10 mils
Ritver Acrylic Antifouling 4 – 6 mils

Under dry and cool condition, Storage stability can be sound up to 18 months in original sealed containers.
HANDLING
Disposal: As per the guidance and legislations of the local Authority e.g., by controlled landfill.
In case of doubt, consult local authority. Do not empty into drains, sewers or other water courses.
Flash Point: 28oC and contains Aromatic Hydrocarbons.
Caution: It is strongly advised not to keep open half used drums as it forms a skin on the top layer.

Avoid contact with the skin and eyes. Wear suitable protective clothing such as overalls, goggles, dust mask and gloves. Use a barrier cream. Other industrial practices are applicable.
Ensure that there is adequate ventilation in the area where the product is being applied. Do not breathe vapor or spray.
MSDS is available on request for the safe handling of this product.
FIRST AID
Eyes: In the event of accidental splashes, flush eyes with warm water immediately and obtain medical advice.
Skin: Wash skin thoroughly with soap and water or approved Industrial cleaner. DO NOT USE solvent or thinners.
Inhalation: Remove to fresh air, loosen collar and keep patient rested.
Ingestion: In case of accidental ingestion DO NOT INDUCE VOMITING. Obtain immediate medical attention.

Related products