• spe_5

    Color

    Pearl White
  • spe_5

    Specific gravity

    0.97 Kg/lit [±0.025]
  • spe_5

    Weight Solids

    42% [± 2]
  • spe_5

    Weight Solid Blended

    38% [± 2]
  • spe_5

    Flash point

    21°C
  • DESCRIPTION
  • USES
  • SURFACE PREPARATION
  • PRODUCT PREPARATION
  • APPLICATION METHODS
  • CLEANING
  • PACKING & STORAGE
  • SAFETY & FLAMMABLE

Special Effect two components Acrylic Hammer Mother of Pearl based on acrylic resin and selected pearlescent pigment, with the addition of special additive that provide a hammer finishes and natural pearl transparent that gives coloristic effect according to the color of the substrate. Suitable to provide an attractive looking effect.

It is recommended for all type of woodworks, kitchens, internal doors and frames, head boards and drawers.
Area to use: Interior

All timber species must be fully aged with a moisture content of less than 15%. Surface must be dry, clean and free from contaminations. Natural oil or gum must be removed by solvent cleaning.
It can be used on veneer substrate, solid wood, and MDF which were treated with pigmented polyurethane or polyester basecoats. Apply two or more coats according to the desired covering. After drying, sand the basecoat with at least 400 type sanding paper. Ensure that no residues on the substrate before application of topcoat.

CATALYST

by weight 20% CP029 by volume 20%

Pot Life 6hrs. @ 25°C
Stir product well with a flat paddle. Add the correct quantity of hardener and stir till homogeneous. Thin to required viscosity. For details of spray equipment contact Ritver Technical Services Department.
DILUTION
Spraying:

Dilute with PU thinner [TP292] at 20-30%.
In case of hot and humid climate, it is necessary to add 5 % of PU retardant thinner [TP222].

Depends on the finishes required but in general an appropriate rate is 100 gr / sq. m. The number of coats depends on the surface preparation the porosity of the substrate, and the finish required.
Following Treatments
Spray gun:

Use spray gun with a 1.8 – 2.0 mm. nozzle at 3-4 atm/bar.
After drying this product does not need any particular subsequent treatment.
Anyway, it is possible to apply on top of MOTHERPEARL HAMMER (after 2 hrs. without sanding) an acrylic top finish glossy (to increase the brightness) or matt (for a matt effect).

Clean all tools and equipment immediately after use with [TC010] Tool Cleaning.

Available in 5Ltr. 25Ltr.
Store in a cool and well ventilated place. Keep away from direct sunlight. 18 months in unopened container, stored in a cool and dry condition at 25°C.

This material is flammable and must not be exposed to naked flames.
Use only in well ventilated areas. In case of insufficient ventilation during application wear suitable respiratory equipment. Do not breathe vapor / spray. In case of contact with eyes, rinse immediately with plenty of sweet water and seek medical advice. In case of contact with skin,wash immediately with soap and water or a recognized skin cleanser.
Keep away from sources of ignition. No Smoking. Keep out of reach of children.