Aluminium Paints

Ritver Aluminum Paints is a general purpose paint based on a suitable modified alkyd resin and containing aluminum flake to provide a tough durable and hardwearing luster finish. It has excellent flow, hiding power, and gloss retention properties and is suitable as a decorative and protective coating. It can resist to a temperature in the range of 220oC.

Substrates: Metal and timber.
Area of Use: Interiors and Exteriors.

A good surface preparation and following the method statement / recommended system procedure of Ritver is an ideal recommendation for the application of Ritver Aluminium Paints.
For Plaster, Masonry & Concrete:
Achieve a good and clean surface by removing all contaminants by cleaning & drying. A laitance free surface should be achieved by good sweep blast or a wire brush. Apply one coat of Ritver Synthetic Red Oxide, followed by Ritver Synthetic Undercoat and proceed for Ritver Aluminum Paints after drying.

Adequate ventilation is an ideal situation as it helps in drying and the good application itself. Avoid high humid conditions i.e., >95% when condensation is likely to interfere and also when the surface temperature is at least 3°C above dew point.
Application: To be done by conventional roller or spray at 2000 – 2500 psi for airless spray or 50 – 60 psi for conventional spray. Nozzle size: 0.009 – 0.011 inches. One can add 5 – 10% of Ritver Thinner for ease of application of brush/roller/or spray viscosity.
Caution: Over diluting would result in sag and run downs.

On a well cleaned surface, apply 1 or 2 coats of about 25 microns the point under study directly on the substrate like metals.

Under dry and cool condition, Storage stability can be sound up to 18 months in original sealed containers.
HANDLING
Disposal: As per the guidance and legislations of the local Authority e.g., by controlled landfill. In case of doubt, consult local authority. Do not empty into drains, sewers or other water courses.
Flash Point: 38oC and contains aromatic hydrocarbons.
Caution: It is strongly advised not to keep open half used drums as it forms a skin on the top layer.

Avoid contact with the skin and eyes. Wear suitable protective clothing such as overalls, goggles, dust mask and gloves. Use a barrier cream. Other industrial practices are applicable.
Ensure that there is adequate ventilation in the area where the product is being applied. Do not breathe vapour or spray. MSDS is available on request for the safe handling of this product.
FIRST AID
Eyes: In the event of accidental splashes, flush eyes with warm water immediately and
obtain medical advice.
Skin: Wash skin thoroughly with soap and water or approved Industrial cleaner. DO NOT USE solvent or thinners.
Inhalation: Remove to fresh air, loosen collar and keep patient rested.
Ingestion: In case of accidental ingestion DO NOT INDUCE VOMITING. Obtain immediate medical attention.