PW 2999_Final Touch Bronze Emulsion

Final Touch BRONZE Emulsion is an economical grade emulsion based on Acrylic copolymer resin with Titanium Dioxide and other light resistant pigments and fillers. It is particularly recommended as and indoor finish where it provides a very good value for money. It gives the surface a smooth and pleasing effect with good brush ability and recoat ability. It is resistant to algae and fungus attacks.

Substrates: Concrete, plaster, masonry, gypsum.
Area of Use: Interiors only.

A good surface preparation is an ideal recommendation for the application of Final Touch BRONZE Emulsion.

For Plaster, Masonry & Concrete:
Achieve a good and clean surface by removing all contaminants and loose particles by cleaning & drying. A laitance free surface should be achieved by good sweep blast or a wire brush. Water washing under pressure is recommended. Apply the Ritver PVA Primer Sealer or Ritver Alkali Resistant Primer and allow drying as per the data sheet and subject to one more coat for even coverage. Apply Ritver Stucco Putty evenly and allow drying and following it up with Final Touch BRONZE Emulsion for one or two coats.

For Old and Painted surfaces:
In case of surfaces which are painted / or aged and is visible dusting, chalking or even friable ensure that all the loose material is removed by scrapping or metal brush. Apply a good coat Ritver Fungicidal wash compound and allow drying. Follow this by a regular coat or two of Ritver PVA Primer Sealer or Ritver Alkali Resistant Primer and continue as in the above case.

Adequate ventilation is an ideal situation as it helps in drying and the good application itself. Avoid high humid conditions i.e., >95% when condensation is likely to interfere and also when the surface temperature is at least 3°C above dew point.

1. Dilution: One can add 5 to 10% of sweet water for ease of application depending on the suitability of application.
2. Brush: It is in ideal recommendation especially to avoid runs and sags due to excess material.
3. Roller: Apply an even coat spreading uniformly taking care to avoid runs.
4. Airless spray: Use tip size around 0.018” to 0.020” and pressure around 150. – 175 Kg/cm².

Or as per Ritver technical advice

Under dry and cool condition, storage stability can be sound up to 18 months in original sealed containers.
HANDLING
Disposal: As per the guidance and legislations of the local Authority e.g. by controlled landfill. In case of doubt, consult local authority. Do not empty into drains, sewers or other water courses.
Flash Point: Not applicable

Avoid contact with the skin and eyes. Wear suitable protective clothing such as overalls, goggles, dust mask and gloves. Use a barrier cream. Ensure that there is adequate ventilation in the area where the product is being applied. Do not breathe vapour or spray.

MSDS is available on request for the safe handling of this product.
FIRST AID
Eyes: In the event of accidental splashes, flush eyes with warm water immediately and obtain medical advice.
Skin: Wash skin thoroughly with soap and water or approved industrial cleaner. DO NOT USE solvent or thinners.
Inhalation: Remove to fresh air, loosen collar and keep patient rested.
Ingestion: In case of accidental ingestion DO NOT INDUCE VOMITING. Obtain immediate medical attention.