Chlorinated Rubber (One Pack)
Ritver Chlorinated Rubber is a one pack Chlorinated Rubber Based Coatings that exhibits excellent weather, and water resistance, has very good resistance to mild acids and bases. The product is designed as topcoat for Epoxy, Chlorinated Rubber or vinyl paint systems used in marine environments. It is an integral part of the Ritver Marine products. The product is carefully formulated to meet the demands of Marine Coatings.
SKU: PS3106
-
Finish
Gloss -
Colour
White and colors available -
Specific gravity
1.20 ± 0.02 -
Solids by Volume
54 ± 1 -
Flash point
28oC
- SURFACE PREPARATION
- APPLICATION METHODS
- TYPICAL PAINT SYSTEM
- STORAGE & SHELF LIFE
- SAFETY PRECAUTION
Always ensure that the surface to be painted must be free of dirt oil and grease. When applied over a fully cured coatings, lightly sand the surface with a fine grit sandpaper, # 320 to # 400 will be enough to provide good adhesion.
Adequate ventilation should always be observed when applying Ritver Chlorinated Rubber. This will ensure proper drying of the material. Never apply this product in adverse weather conditions such as when the temperature is below 5oC or when the humidity level is above 90%. The surface temperature should always be kept at not less than 3 degree above dew point. In confined spaces constant purging of air during application and drying is necessary to eliminate solvent vapors for reason of health and safety and to assist solvent evaporation.
Application:
The recommended method of application is by airless or air assisted airless spray. However the product can also be applied using conventional spray or brush. The addition of Ritver Marine Thinner depends on the application methods used which is in the range of 10 to 20 percent.
Ritver Chlorinated Rubber | Ritver Epoxy Zinc Chromate Primer | 1 mil |
*Or as per Ritver technical advic | Ritver Epoxy Zinc Rich Primer | 4 – 6 mils |
Ritver Epoxy High Build Intermediate | 8 – 10 mils | |
Ritver Chlorinated Rubber | 4 – 6 mils |
Under dry and cool condition, Storage stability can be sound up to 18 months in original sealed containers.
HANDLING
Disposal: As per the guidance and legislations of the local Authority e.g., by controlled landfill.
In case of doubt, consult local authority. Do not empty into drains, sewers or other water courses.
Flash Point: 28oC and contains Aromatic Hydrocarbons.
Caution: It is strongly advised not to keep open half used drums as it forms a skin on the top layer
Avoid contact with the skin and eyes. Wear suitable protective clothing such as overalls, goggles, dust mask and gloves. Use a barrier cream. Other industrial practices are applicable.
Ensure that there is adequate ventilation in the area where the product is being applied. Do not breathe vapor or spray.
MSDS is available on request for the safe handling of this product.
FIRST AID
Eyes: In the event of accidental splashes, flush eyes with warm water immediately and obtain medical advice.
Skin: Wash skin thoroughly with soap and water or approved Industrial cleaner. DO NOT USE solvent or thinners.
Inhalation: Remove to fresh air, loosen collar and keep patient rested.
Ingestion: In case of accidental ingestion DO NOT INDUCE VOMITING. Obtain immediate medical attention