Eposreed 10

EPOSCREED 10 is a three components epoxy resin system. It is an epoxy flooring screed which should be applied at a 3 – 10.0 mm thickness. EPOSCREED 10 forms a hard build screed with excellent adhesion to concrete, and abrasion resistance.

EPOSCREED 10 is used in heavy steel engineering plants, workshops, dairies,soft drinks production and bottling plants, kitchens, showrooms, wet working areasand other areas with chemical spillage.
EPOSCREED 10 provides a hard wearing, easily cleaned and attractive floor coatings in areas where high resistance to chemical attack is required.
EPOSCREED 10 is used as a final coat and sealer for concrete floors, non-skid coat when sprinkled over with quartz granules and as a finish coat for epoxy floor screeds to provide a more durable and easily cleaned surface where high impact is desirable.

• Non-slip finishing.
• Fast curing comparing to cement screed.
• High impact resistance.
• Hard wearing – durable.
• High abrasion resistance.
• High compressive strength
• Provides hygienic – impervious finish
• Human safe.
• Solvent free.
• Available in different colors.

All surfaces should be clean, dry and free from dust and other contaminants. A dry sponge should be used to remove water on wet surfaces. Treat oil or grease contamination should be removed by degreaser followed by water or steam cleaning.
New concrete floors should be cured for at least 28 days and should have a moisture content of less than 5%. Excessive laitance should be removed by mechanical method. Dust and other debris should be removed by vacuum cleaning. The substrate should be dry and relative humidity should not exceed 75% as per BS 8201.
Old concrete floors damaged areas or surface irregularities should be separately repaired as batch areas using EPOMORTAR FC (fast curing epoxy mortar, refer toTDS). Steel surface should be grit blasted then cleaned by solvent and kept to dry.

The entire contents of the hardener container should be poured into the base container and the two materials mixed thoroughly for at least 3 minutes. Use a heavy duty slow speed power drill with a jiffy mixing blade. Mix the two components in the quantities supplied ensuring that the hardener container is scraped clean. Immediately start adding the aggregate bag gradually while mixing.

Priming is recommended for concrete surfaces using PRIME EP100, a two
component, high solid content epoxy primer – refer to the relevant technical data sheet.
EPOSCREED 10 should be applied to prepared surface using a steel trowel then tamped with a wooden float for more compacting.
CONCOAT EP150 (refer to the relevant technical data sheet) can be applied as an epoxy overcoat.
COVERAGE
Application rate will vary according to surface conditions, surface profile,application technique and job conditions. A coverage rate of 2.4 m2/pack at 5 mm DFT is required.
CLEANING
Tools and equipments should be cleaned immediately by using THINNERCOAT 10.
PACKAGE
12 litr pack (including, hardener and aggregate)
STORAGE
Product should be stored at 25°C in dry conditions.
FLAMMABILITY
EPOSCREED 10 is a non-flammable material.
THINERCOAT 10 is flammable. Do not expose to naked flames during application.
SHELF LIFE
12 months in a tightly closed container.

Full Cure7 days at 35 0C.

The material should be applied in a good ventilated area. Avoid inhalation of the vapors. Use goggles and vinyl gloves. In case of eye contact, rinse immediately with plenty of clean water, do not use solvent and seek medical help immediately. The product complies with environmental and occupational health & safety standards ISO 14001 and OHSAS 18001.