Epoxy Primer Solvent Free

PRIME EP100 is used as a base coat for receiving an epoxy floor coating system.
PRIME EP100 is used as a base coat for polyurethane deck floor coating system.
PRIME EP100 is used as a sealer for concrete floors and as a base coat for epoxy floor screeds to provide a more adhesion to surface where high impact is desirable.
PRIME EP100 is used as a dust proof for concrete floors.
PRIME EP100 is used as a top coat for stamp and decorative concrete floors.

• One coat application.
• Penetrating primer.
• High build to use shotblas.
• Excellent adhesion.
• Reduces bubbling and pinholes.
• Easy to apply by roll, brush and airless spray.
• Clear finish coat.

All surfaces should be clean, dry and free from dust and other contaminants. A dry sponge should be used to remove water on wet surfaces. Treat oil or grease contamination should be removed by degreaser followed by water or steam cleaning.
New concrete floors should be cured for at least 28 days and have a moisture content of less than 5%. Excessive laitance should be removed by mechanical method. Dust and other debris should be removed by vacuum cleaning.
Old concrete floors damaged areas or surface irregularities should be repaired by using EPOMORTAR FC two component fast curing epoxy mortar (Refer to TDS).
Steel surface should be grit blasted then cleaned by solvent and kept to dry.
Deep spots or trowel marks should be rubbed down. Dust and debris should be removed by vacuum cleaning then repaired by using EPOSCREED 10 three component epoxy screed (Refer to TDS.)

The entire contents of the hardener container should be poured into the base container mixed thoroughly for at least 3 minutes. Use a heavy duty slow speed power drill with a jiffy mixing blade. Mix the two components in the quantities supplied ensuring hardener container is scraped clean. Do not add solvent thinners at any time

PRIME EP100 is recommended to be apply in one or two coats. PRIME EP100 can be applied to prepared surface using airless spray, brush or roller. Ensure that the area is completely coated

10.0 m2 / litr at 100 microns (WFT) in one coat

Tools and equipment should be cleaned immediately by using THINNERCOAT 10 organic solvent.

5.0, 10.0 litr packs (including base and Hardener)

Product should be stored at 25°C in dry conditions and kept away from source of flame.

PRIME EP100 is a nonflammable material.
THINERCOAT 10 so do not expose to naked flames during application.

12 months in tightly closed container.

The material should be applied in a good ventilated area. Avoid inhalation of the vapors.
Use goggles and vinyl gloves. In case of eye contact, rinse immediately with plenty of clean water, do not use solvent and seek medical attention immediately.
The product complies with environmental and occupational health & safety standards ISO 14001 and OHSAS 18001.