Nc white Crackle

Special Effect, NC solution modified with selected resin and superior filler, developed to provide the surface with dramatic cracking effect and to display a very unique and antique finishes.

For furniture in general, cabinet, drawers, picture frames, chairs and turned pieces.
Area to use: Interior

All timber species must be fully aged with a moisture content of less than 15%. Surface must be dry, clean and free from contaminations. Natural oil or gum must be removed by solvent cleaning.
It can be used on veneer substrate, solid wood, and MDF which were treated with pigmented NC basecoats. Apply two or more coats according to the desired covering. After drying, about 1hour without sanding, we apply NC Crackle.
Stir product well with a flat paddle. Thin to required viscosity. For details of spray equipment contact Ritver Technical Services Department.

Dilution
Spraying:
Dilute with NC thinner [TN190] at 70 -80 %.
In case of hot and humid climate, it is necessary to add 5 % of NC Retardant Thinner [TN122].

Depends on the finishes required but in general an appropriate rate is 100 gr / sq. m. The number of coats depends on the surface preparation the porosity of the substrate, and the finish required.
Following Treatments
Spray gun:
Use spray gun with a 1.8 – 2.0 mm. nozzle at 3-4 atm/bar. It can be applied by air mix spray application. In the last case of preliminary test, for spray application the ideal reduction is 20-30%.
NB: The crackle effect appears during the drying stage (after about 5-10 minutes), and is enhanced by a suitable contrast between the colour of the basecoat and the colour of the crackle topcoat.
A wide range of different crackle patterns can be obtained with NC Crackle, simply by varying the amount of thinner, the quantity of sprayed product and the spraying method. After drying interval a period of 4-5 hours minimum, it is recommended to overcoat NC clear matt or gloss, to provide the special effect finish created a full protection against scratch.

Clean all tools and equipment immediately after use with [TC010] Tool Cleaning.

Available in USG, 5USG.
Store in a cool and well ventilated place. Keep away from direct sunlight. 18 months
in unopened container, stored in a cool and dry condition at 25°C.

This material is flammable and must not be exposed to naked flames.
Use only in well ventilated areas. In case of insufficient ventilation during application wear suitable respiratory equipment. Do not breathe vapor / spray. In case of contact with eyes, rinse immediately with plenty of sweet water and seek medical advice. In case of contact with skin, wash immediately with soap and water or a recognized skin cleanser. Keep away from sources of ignition. No Smoking. Keep out of reach of children