Polyster Clear For Horizontal Use (Cat @2% E/1049 & Accelerater @2%)

Superior grade three components polyester topcoat, based on unsaturated polyester resins, designed as self-resolving multicoat, provides good reactivity, very good hardness, excellent clarity and good elasticity. Successive sanding, buffing and polishing treatment is necessary to obtain a full gloss surface.

It is indicated for horizontal surfaces of wooden furniture for interior, not suitable for exterior

All timber species must be fully aged with a moisture content of less than 15%. Surface must be dry, clean and free from contaminations. Natural oil or gum must be removed by solvent cleaning.
To obtain optimum surface finish sand the wood properly in the same direction of the wood grain, utilize sanding paper no. [100]. before polyester basecoat application, it is strongly recommended to apply [PI280 or PI281] PU Isolate to prevent possible defects (lack of adhesion, bubbles, pin holes) caused by the incompatibility of the wood with unsaturated polyester

ACCELERATOR

ALTERNATIVE ACCELERATOR

CATALYST

Depends on the finishes required but in general an appropriate rate is 180 gr / sq.m. / coat. The number of coats depends on the surface preparation the porosity of the substrate, and the finish required.
Following Treatments
By spray gun: Utilizing 2-2.5 mm nozzle at 3-4 ATM/bar, or with airless spray.
For details of spray equipment contact Ritver Technical Services Department.
Non – Absorbent supports 100 – 120 g/sq. m. is sufficient Absorbent Substrates 160 – 200 g/ sq. m can be applied.
If more coats are required, these can be applied in two ways. 1) Wet-on-Wet with 30 – 60 minutes between coats 2) Apply a second coat once the first coat is fully dry, with an intermediate

Clean all tools and equipment immediately after use with [TC010] Tool Cleaning.

Available in 5Ltr, 25Ltr.
Store in a cool and well ventilated place. Keep away from direct sunlight. Shelf life 6 months in unopened container, stored in a cool and dry condition at 25°C.

This material is flammable and must not be exposed to naked flames.
Use only in well ventilated areas. In case of insufficient ventilation during application wear suitable respiratory equipment. Do not breathe vapor / spray. In case of contact with eyes, rinse immediately with plenty of sweet water and seek medical advice. In case of contact with skin, wash immediately with soap and water or a recognized skin cleanser.
Keep away from sources of ignition. No Smoking. Keep out of reach of children.