• spe_5

    Appearance

    5%, 10%, 30%, 50%, Gloss
  • spe_5

    Color

    White
  • spe_5

    Specific gravity

    1.24 Kg/L [±0.025]
  • spe_5

    Weight Solids

    Approx. 61% [± 2]
  • spe_5

    Flash point

    21°C
  • USES
  • SURFACE PREPARATION
  • PRODUCT PREPARATION
  • APPLICATION METHODS
  • CLEANING
  • PACKING & STORAGE
  • SAFETY & FLAMMABLE

For interior use on all furnishings as wardrobes, closet, paneling, doors, windows frame, and casting, etc. The overall characteristics such as extensibility, Matt effect equalization, pigmentation and resistance to polishing have been developed to the maximum which in turn enables the product to have almost unlimited possibilities in the furniture industry

All timber species must be fully aged with a moisture content of less than 15%. Surface must be dry, clean and free from contaminations. Natural oil or gum must be removed by solvent cleaning.
To obtain optimum surface finish sand the wood properly in the same direction of the wood grain, utilize sanding paper no. [100] , then and after surface leveling , utilize paper No.[220] to create smoothness to the substrate , then utilize paper No.[400 ] to achieve perfection of Substrate, as is adequate sanding and removal of dust prior to application of first coat. Control the compatibility of Stains eventually used.

CATALYST

By weight By volume
50% CP001 / CP003 NY 60%

Pot Life 3 hrs. @ 25°C Stir product well with a flat paddle. Add the correct quantity of hardener and stir till homogeneous. Thin to required viscosity. For details of spray equipment contact Ritver Technical Services Department.

Dilution
Utilize [TP292] PU Thinner depending on the application system used. In general 20 -30% thinner is added to achieve an application viscosity. This is suitable for spraying.
For Curtain coater 20% Thinner is added to achieve an application viscosity. In case of high humidity climate add 5-10% [TP222] PU retardant thinner.

Depends on the finishes required but in general an appropriate rate is 140 gr / sq. m. The number of coats depends on the surface preparation the porosity of the substrate, and the finish required.
Following Treatments
By spray gun:
By Curtain Coater:
Utilize nozzle 1.8 – 2 mm at 3-4 ATM/bar. For details of spray equipment contact Ritver Technical Services Department.
It is recommended to control the viscosity during application by adding PU Thinner to balance the evaporation of solvents.

Cleaning
Clean all tools and equipment immediately after use with [TC010] Tool Cleaner.

Available in 5Kg, 25Kg.
Store in a cool and well ventilated place. Keep away from direct sunlight. Maximum 18 months in unopened container, stored in a cool and dry condition at 25°C.

This material is flammable and must not be exposed to naked flames.
Use only in well ventilated areas. In case of insufficient ventilation during application, wear suitable respiratory equipment. Do not breathe vapor / spray. In case of contact with eyes, rinse immediately with plenty of sweet water and seek medical advice. In case of contact with skin, wash immediately with soap and water or a recognized skin cleanser.
Keep away from sources of ignition. No Smoking. Keep out of reach of children.