PU WATER BASE PIGMENTED GLOSSY FOR INTERIOR

A waterborne odorless Polyurethane topcoat pigmented gloss, based on low solvent contents and excellent flow leveling, provides a top performance in terms of covering, drying and hardness. Compared to traditional Water Borne PU finishes, it is designed as topcoat on pieces previously treated with pigmented water basecoat. [This material is following the LEED certificateCREDIT EQ C4.2, as per the rules 1113 for the architectural coating, it has a VOC less water and exempt solvents less than 24.5 g/l]

For Interior use, such as varnishing doors and furniture and as a finish on pieces previouslytreated with pigmented water basecoat.

All timber species must be fully aged with a moisture content of less than 15%. Surface must be dry, clean and free from contaminations. Natural oil or gum must be removed by solvent cleaning.
We suggest a good sanding of the wood substrate treated with pigmented basecoats such as [WBI10246] PU Primer, before applying [WBI10255-color] PU pigmented gloss.
Control the compatibility if other products are used as basecoats.

Stir product well with a flat paddle. Thin to required viscosity. For details of spray equipment contact Ritver Technical Services Department.
Dilution
Product ready for use. Eventually it is possible to dilute with water at 5-10% max.

Depends on the finishes required but in general an appropriate rate is 130 gr / sq. m. The number of coats depends on the surface preparation the porosity of the substrate, and the finish required.
Following Treatments
By spray gun. The product is ready for use; in winter time it is not advisable to thin down the product but it is recommend to use the pre-heater set between 35°C and 45°C; in warmer times it is advisable to thin down the product from 5% up to 10% max. with water and to use the pre-heater at a max. temperature of 35°C. The product viscosity generally enables the application of 100-120 micron humid thickness without dripping; it is not advisable to apply higher thickness as film sanding and flow levelling would be impaired. Suggested nozzle: for airless 09 fixed or 015 adjustable at 4 atm/bar of pressure; for normal spray gun 2.0 mm. at 3.5-4 atm/bar of pressure. Check very carefully that the spray-gun does not show any trace whatsoever of solvent from previous applications. It is advisable to wash varnishing tools immediately after use.

Clean all tools and equipment immediately after use with water

Available in USG, 5USG.
Store in a cool and well ventilated place. Keep away from direct sunlight. Maximum 18 months in unopened container, stored in a cool and dry condition at 25°C.

This material is flammable and must not be exposed to naked flames.
Use only in well ventilated areas. In case of insufficient ventilation during application wear suitable respiratory equipment. Do not breathe vapor / spray. In case of contact with eyes, rinse immediately with plenty of sweet water and seek medical advice. In case of contact with skin, wash immediately with soap and water or a recognized skin cleanser.
Keep away from sources of ignition. No Smoking. Keep out of reach of children.