Varnish Glossy Fast Dry UV

Ritver Varnish Glossy Fast Dry UV is a mono component product based on especially suited modified oil Alkyd resin. It is a fast drying product used as wooden varnish with high mechanical resistance and very good abrasion.

Substrates: Wooden substrates.
Area of Use: Interior and exterior

A good surface preparation and following the method statement / recommended system procedure of Ritver is an ideal recommendation for the application of Ritver Varnish Glossy
Fast Dry UV.
For wood: Achieve a good and clean surface by removing all contaminants by cleaning & drying. Wood may be treated with Ritver Wood Preservative before application.
Apply one coat of Ritver wood preservative if needed followed by one to two coats of Ritver Varnish Glossy Fast Dry UV after drying.
Apply two good coats with a spray or a suitable brush / roller and obtain the desired coverage.
Exclusions for successful application include perpetually wet surfaces and also large cavities on wood surfaces

Adequate ventilation is an ideal situation as it helps in drying and the good application itself. Avoid high humid conditions i..e., >95% when condensation is likely to interfere and also
when the surface temperature is at least 3°C above dew point.
Application: To be done by conventional roller or spray at 2000 – 2500 psi for airless spray or 50 – 60 psi for conventional spray. Nozzle size: 0.015 – 0.018 inches. It is ideal to apply one coat and
One can add 5 – 10% of Ritver General Purpose Thinner for ease of application of brush/roller/or spray viscosity.
Caution: Over diluting would result in sag and run downs.

Under dry and cool condition, Storage stability can be sound up to 18 months in original sealed containers.
HANDLING
Disposal: As per the guidance and legislations of the local Authority e.g., by controlled landfill. In case of doubt, consult local authority. Do not empty into drains, sewers or other water courses.
Flash Point: 38oC and contains mineral spirit.
Caution: It is strongly advised not to keep open half used drums as it forms a skin on the top layer.

Avoid contact with the skin and eyes. Wear suitable protective clothing such as overalls, goggles, dust mask and gloves. Use a barrier cream. Other industrial practices are applicable.
Ensure that there is adequate ventilation in the area where the product is being applied. Do not breathe vapour or spray. MSDS is available on request for the safe handling of this product.
FIRST AID
Eyes: In the event of accidental splashes, flush eyes with warm water immediately and obtain medical advice.
Skin: Wash skin thoroughly with soap and water or approved Industrial cleaner. DO NOT USE solvent or thinners.
Inhalation: Remove to fresh air, loosen collar and keep patient rested.
Ingestion: In case of accidental ingestion DO NOT INDUCE VOMITING. Obtain immediate medical attention.